Four Repair Services
Four commercial roof repair services cover Tempe flat, metal, and plant roofs, plus the leak tracing that tells you which one your building needs.
The roof system and the symptom point to the service. When the symptom is a stain with no obvious source, leak repair comes first.
For low-slope roofs covered in TPO, EPDM, modified bitumen, or built-up gravel, where seams, blisters, drains, and parapet flashing are the trouble spots.
Warehouses and shops with ribbed or standing-seam panels, where loose screws, open laps, rust, and old skylights let water in.
Any roof with water inside and no clear source. Tracing follows the deck from the stain upslope to the opening that actually leaks.
Plant and fabrication roofs carrying fans, stacks, and dust collectors, where residue, vibration, and production schedules shape the work.
The roof you have and the symptom you see narrow it down quickly.
| Roof System | What Usually Fails | Service To Call |
|---|---|---|
| TPO or EPDM single-ply | Seams, curb corners, edge shrinkage | Flat roof repair |
| Built-up gravel or mod bit | Bare spots, blisters, open laps | Flat roof repair |
| Exposed-fastener metal | Screws, washers, laps, skylights | Metal roof repair |
| Plant roof with equipment | Fan and stack curbs, residue, supports | Industrial roof repair |
| Any roof, unclear source | A stain far from any obvious opening | Leak repair |
Call first, before the tile gives way. Tell us the room and the roof system if you know it, and we will start with temporary control.
Whichever service fits, the visit runs the same five steps, and the paperwork looks the same.
The first walk identifies the roof system, checks every detail where membrane or panels stop and turn, and scans for wet insulation.
On The Roof
Problems get numbered on a roof sketch with photos, so the repair list and the estimate match line for line.
Paperwork
Access routes, work hours, and coverings for equipment get agreed before the first cut or the first screw comes out.
At The BuildingWelds, seam tape, ply patches, or fasteners and butyl tape, depending on what the roof is made of.
On The RoofRepairs get tested where the roof allows, and the numbered sketch comes back to you with photos of each item.
PaperworkAnswers on stopping active leaks and choosing a service.
Yes. Temporary leak control is common while the permanent fix gets planned: clearing a blocked drain or scupper, taping a split seam with a compatible tape, or weighting a membrane patch over a torn section.
Inside, plastic sheeting protects equipment and inventory. The stopgap buys time until the roof dries and the entry point is confirmed.
The first roof walk identifies it. You only need to tell us where water shows inside and how to reach the roof.
One work order can. A metal shop with a flat addition gets both repairs on it, and leak tracing often runs ahead of whichever repair follows.
Repairs are the focus here. When the roof walk shows replacement makes more sense, you get that call in writing with the reasons and photos.
Describe the roof system if you know it, and where water shows inside. We will match the repair to it.
Want A Call Back About Your Roof?
Leave a name and number, or call (623) 310-0181 now.